Encender
- 1Press 전원 (bottom row, right).
Kiturami NCTR-60W explicado
A white Kiturami controller with a silver push-dial, 난방/온수 buttons beside it and a row of four buttons (예약 · 외출 · 온돌 · 전원) underneath.
¿Qué hace cada botón?
- 1Current temp · 현재온도hyeonjae ondoLeft number: room temperature now.
- 2Set temp · 희망온도huimang ondoRight number: the hot-water temperature you set.
- 3Running · 운전unjeonGreen = boiler running.
- 4Room heating · 난방nanbangRoom-thermostat mode: tap, turn the dial to 10–45°C, press the dial. Hold 5 s = summer hot-water-only.
- 5Hot water / Bath · 온수onsuTap once: set hot-water temp with the dial. Tap twice: 목욕 bath mode.
- 6Dial (turn + press) · 다이얼daieolTurn − / + to change the number, press in to save.
- 7Repeat timer · 예약yeyakRun X minutes (10–90), rest Y hours (1–24), repeat. Each press swaps which value you are setting.
- 8Away · 외출oechulHolds the room at a fixed 8°C for frost protection.
- 9Floor mode · 온돌ondolHeats by floor-water temperature (45–85°C), ignoring the room sensor.
- 10Power · 전원jeonwonOn/off and error restart.
¿Qué ajuste uso?
Winter: 난방 at 21–22°C (or 온돌 75–80 if the controller sits in a draughty spot). Hot water as low as is comfortable. Away: 외출.
¿Cómo…?
Calentar la habitación a una temperatura
- 1Press 난방 (small round button, left).
- 2Turn the dial to 22 (range 10–45°C).
- 3Press the dial in to save.
Modo suelo (ondol)
- 1Press 온돌 (bottom row).
- 2Turn the dial: winter 75–85, early winter 70–80, autumn 65–75, spring 60–70 (range 45–85°C).
- 3Press the dial to save.
Salir unos días
- 1Press 외출 (bottom row). Room is held at 8°C.
- 2Keep power on. In extreme cold use 난방 at 10°C instead.
Programar
- 1Press 예약. Two numbers show: 가동 (M = minutes on) and 정지 (H = hours off).
- 2Press 예약 again to switch which one flashes; turn the dial to set it (10–90 min / 1–24 h). Default run time is 20 min.
- 3Press the dial to finish. Example: 20 min on / 2 h off.
Solo agua caliente (verano)
- 1Press and HOLD 난방 for about 5 seconds.
- 2Only 온수 shows — heating is off.
- 3Tap 난방 once to bring heating back.
Ajustar el agua caliente
- 1Tap 온수 once.
- 2Turn the dial (55–80°C on this manual's boiler type; 35–60°C on instant boilers). Aim for the lowest comfortable value.
- 3Press the dial to save. Tap 온수 twice for 목욕 (bath).
Apagar
- 1Press 전원. In winter use 외출 instead.
¿Qué significan las palabras de la pantalla?
| 난방 | Room heating | Room-thermostat mode on. |
|---|---|---|
| 온돌 | Floor mode | Heating by floor-water temp. |
| 온수 | Hot water | Hot water on (works in every mode). |
| 목욕 | Bath | Extra-hot water for 2 h 30 min. |
| 예약 · 가동 __M · 정지 __H | Timer | Runs __ minutes, rests __ hours. |
| 외출 | Away | Frost protection, fixed 8°C. |
| 절약 | Saving | Saving mode indicator. |
| flame icon | Burning | Burner is firing. |
| 운전 | Running | Boiler running. |
Trampas de este modelo
- Turning the dial is not enough — press the dial in to save.
- Summer hot-water-only = HOLD 난방 for 5 s (the quick-start note in the manual says 'press 온수' but the detailed page says hold 난방).
- The right number is hot water, not the room.
- 목욕 auto-returns to the previous mode after 2 h 30 min.
¿Sale un código de error?
Error codes show on the screen. Press 전원 off/on once; if it repeats call 1588-9000.
Servicio técnico (coreano): 1588-9000