How do I turn on the Unbranded 5-room zone controller (전원/기능/방선택/예약)?

1. Press 전원 once. The screen and flame icon appear.

How do I set the room temperature on the Unbranded 5-room zone controller (전원/기능/방선택/예약)?

1. Press ▲ until 설정온도 reads 21. 2. Wait a few seconds for it to save. 3. Heating runs while 현재온도 is below 설정온도.

1. Easiest safe method: lower 설정온도 to about 10°C with ▼. 2. Or press 기능 until an Away/외출 mark shows (not verified).

1. Press 전원 again, or set 설정온도 below the current temperature.

A living-room master thermostat for a 5-room zoned floor-heating system: it shows current vs set temperature and can switch between rooms 1-5.

이 모델의 설명서를 찾지 못해 가장 비슷한 모델 기준으로 정리했어요. 다르게 작동하면 사진을 보내주세요.

1Flame icon · Heating mode indicator for the selected room.
2House icon · Probably the Away/home-mode indicator. Not verified.
3Current temperature · 현재온도hyeonjae ondoRoom temperature now (20°C).
4Set temperature · 설정온도seoljeong ondoTarget (15°C). Because 20 > 15, this room is not calling for heat.
5Room numbers · 1 2 3 4 5The rooms on this system. The selected room is highlighted.
6Power · 전원jeonwonTurns heating on or off for the selected room.
7Function · 기능gineungCycles through modes (likely Away / timer / temperature). Not verified.
8Up · ▲Raises the set temperature or value.
9Room select · 방선택bangseontaekSteps through rooms 1-5 so you can set each room from here.
10Reservation / timer · 예약yeyakDelayed or cycle heating. The scheme is not verified for this model.
11Down · ▼Lowers the set temperature or value.

20-21°C in rooms you use, 15-17°C in empty rooms. Change one room at a time with 방선택.

현재온도	Current temp	Measured room temperature.
설정온도	Set temp	Target. Heat flows only while current is below set.
1-5	Rooms	Zones on the system; the highlighted one is the room you are editing.

15°C set with 20°C current means no heat at all. Raise the set number above the room temperature.
Room select changes which room you are editing. Check the highlighted number before pressing ▲/▼.

A/S: Not printed on panel.

출처