켜기
- 1If the screen says 난방꺼짐, tap 난방/외출 for 1 second.
- 2Tap 난방/외출 once more if it shows 외출.
Honeywell Home DT300 series room unit (DT300ST-R/S type) 영어 설명
A Honeywell Home touch thermostat for one room of a zoned floor-heating system: one key for heat/away, two timer keys and ▽△ for temperature.
각 버튼은 무슨 기능인가요?
- 1Indicator lamp · Small status lamp.
- 2Screen · Shows room temperature, set temperature, room number and mode marks.
- 3Heating OFF (long-term) · 난방꺼짐nanbang kkeojimShown after holding 난방/외출 for 3 s. Heating stays off (frost protection still kicks in below 5°C).
- 4Down · ▽Lower set temperature (or timer value).
- 5Up · △Raise set temperature (or timer value). Range 5-35°C.
- 6Heat / Away · 난방/외출nanbang/oechulTap to toggle Heat and Away. Hold 3 s for long-term OFF (난방꺼짐); tap 1 s to cancel.
- 7Delayed heat · 예약난방yeyak nanbangHold 3 s, set 1-24 h: heating stays off for that many hours, then resumes at your set temperature.
- 8Minutes-per-hour heat · 시간난방sigan nanbangHold 3 s, tap once, set minutes: it heats that many minutes each hour regardless of temperature.
어떤 설정이 좋나요?
Heat mode at 21-22°C. Use 외출 for a day out and 난방꺼짐 only in spring/summer.
어떻게 하나요?
실내 온도 맞추기
- 1Tap △ until the set temperature reads 22.
- 2The flame appears while the room is below 22°C.
며칠 집 비울 때
- 1Tap 난방/외출 once; 외출 appears.
- 2Tap it again when back: it returns to the previous setting.
예약 설정
- 1Delayed heat: hold 예약난방 3 s, tap △ for hours (e.g. 3), wait 5 s. Off for 3 h, then normal heating.
- 2Cancel: hold 예약난방 3 s ('00h').
- 3Minutes-per-hour: hold 시간난방 3 s, tap it once more, set e.g. 10 with △ (= 10 min heat / 50 min off), wait 5 s.
- 4Cancel: hold 시간난방 3 s and set 00 with ▽.
끄기
- 1Hold 난방/외출 for 3 seconds until 난방꺼짐 shows.
- 2Tap 1 second to cancel.
화면 글자는 무슨 뜻인가요?
| 난방꺼짐 | Heating off | Long-term off mode. |
|---|---|---|
| 외출 | Away | Away mode on; tap 난방/외출 to return to your previous setting. |
| 🔥 | Heating | Set temperature is above room temperature and the valve is open. |
| h | Hours | Delayed-heat (예약) countdown in hours. |
| 분 | Minutes (flashing) | Minutes-per-hour (시간난방) mode is active. |
| boiler | Boiler error | Error reported by the boiler; contact the boiler maker. |
이 모델에서 자주 헷갈리는 점
- 시간난방 ignores the thermostat: 50 means 50 min of every hour, all day. It is easy to run up a big bill.
- 예약난방 is a DELAY (off first, then on), not 'heat for N hours'.
- District heating: do not stop heating by unplugging the valve box or flipping the breaker. Valves can fail open and heat (and bill) nonstop. Use the thermostat.
- The screen in the photo says 난방꺼짐: the room will stay cold until you tap 난방/외출.
에러가 떠요
'boiler' on screen = boiler fault, call the boiler maker. If the flame shows but the floor stays cold, check that the matching actuator LED under the sink is lit; if it is and there is no water sound, call the management office (district) or the boiler A/S.
A/S: Not printed on panel. Honeywell Home / Resideo A/S 1544-0418.